-
Part code 405533 is a self adhesive seal for additional sealing when doors are slightly bowed, or not quite sealing correctly and in Australia for 'Smoke Stop' requirements. ...
-
Below is the list of commonly used glazing blocks and compensation blocks. Whilst the compensating blocks are customized to suite the profiles, the glazing packers below are nothing "special" and any typical glazier would have blocks that shou...
-
The drive that Starke uses is the Comunello L25 Comunello L25-35 Drive Installation Instructions.pdf ...
-
...
-
...
-
Using WD40 and a clean cloth, before and after video:
...
-
Last Updated: 07/05/2024
in AMBIANCE - uPVC General
Factory fitted reveals are a common request, and easily done in uPVC as the below video explains. PDF shown below can be accessed here: Liner Application 60mm Ambiance2.00.pdf
...
-
Hinge Door Handle Heights can be altered to suit customers requirements though this is rarely a requirement. The default handle height is 1000mm from the Sash Rebate Position (SRP - see below in green), which translates into approx. 1070mm from...
-
Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 - Pin position while cutting the excess Step 9 - Where to cut new stay arm (after step 8) New Stay in position Step 10 ...
-
See Also: https://starke.knowledgeowl.com/help/e-lok-setting-up-your-e-lok-door-for-the-first-time https://starke.knowledgeowl.com/help/setting-up-the-key-override-on-your-e-lok-door ...