-
The diagram below is a helpful guide, but does not replace fully studying NZ4211 or Building Code F4 ...
-
Download and unzip a copy of the Starke Order Comparer tool: Starke Order Date Comparer.zip
...
-
Aspect Ratio Warning on Sliders The uPVC industry worldwide recommends not to exceed a ratio of 2:1 where the height of the sash should not be more than double the width of sash. The reason for this is that when the sash gets too high, relative...
-
Created On: 23/09/2024
in Powder Coating
Square Meters Calculator
Total Square Meters Calculator
Item Periphery (PP in mm):
Item Length (L in mm):
Quantity of Items (Q):
Calculate Total M²
...
-
Sealant Quantity Calculator Calculate the number of 600ml tubes of silicone you will need to seal a window (or houselot). Suggestion is that a 15mm x 15mm bead of silicone is allowed for.
Total Window Perimeter (Metres): ...
-
...
-
Part code 405533 is a self adhesive seal for additional sealing when doors are slightly bowed, or not quite sealing correctly and in Australia for 'Smoke Stop' requirements. ...
-
Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Step 8 - Pin position while cutting the excess Step 9 - Where to cut new stay arm (after step 8) New Stay in position Step 10 ...
-
Created On: 10/09/2024
in AMBIANCE - uPVC General
Every uPVC item that is cut in the Starke CNC has a label on it similar to below. The elements on this label are as follows: Window number from plans, eg “Window 6” Room number from plans, eg “Bedroom 3”. Note, sp...
-
Hinge Door Handle Heights can be altered to suit customers requirements though this is rarely a requirement. The default handle height is 1000mm from the Sash Rebate Position (SRP - see below in green), which translates into approx. 1070mm from...